IVAR a.s.

TMC

 
 

*****

 
  
  

About TMC

The Net
Ind. Network

Line
adapters

Terminals
 
940 PROX+
PROXFinger
PROX+F/G
family
TRAX+
family
TRAX+G
family
928 Finger
TRAX+G
951 IOX
921
AdapTRAX
914 HotMAX

Input
device

Software
Support
 

Our contact
e-mail address:


ivar@ivar.cz


Print this page:

Tisk


Information
in Czech



Terminals

PROXFinger

The simplest and safest "1-to-many" fingerprint identification system


Deal no longer with badges that can be lost, or copied or become unreadable with age.


PROXFingerPROXFinger is the result of adding to a PROX+ thefinger print reading capability provided by theFingerScan Kit. This combination makes you surethat a certain user code recorded in the passageslog belongs to the same user who entered fromthe associated gate.
The PROX+ terminals must be equipped with aPCMCIA memory card running a special C program.Each terminal can drive up to six fingerprint-scanningunits (FingerScan) through a 485 network.The use of RS485 allows scanning units to bemounted even at hundreds of meters from thecontrolling PROX+ terminal.

 

 

STORING FINGERPRINT

For a fingerprint to be recognized, it must bepreviously scanned storing the resulting image,associated to a user code, in the FingerScanmemory. The recording process is a triple scanand needs to be performed only once in one ofthe scanning units of the system. The imageobtained can be downloaded and transmitted tothe other FingerScan units where that user has tobe recognized.

Up

 

"1-to-many" IDENTIFICATION

Each fingerprint is recognized in a few secondswith a false acceptance ratio lower than 0,000001%.No fingerprint image is transmitted over the RS485network because the match is performed insideeach scanning unit where the authorizedfingerprints are stored. Only the associated usercode is transmitted to the PROX+ terminal thattreats it like a code read from a standard magneticbadge. PROX+ functions are available: verifyingtime zones, applying all the programmed accesscriteria, requesting PIN, opening a relay, recordingthe code and so on.

Up to ten fingerprint images can be associated to each user code and up to 1800 images can be stored in a single FingerScan.

Up

 

REMOTE CONTROL

The PROX+ terminal can be controlled by a PC through an Ethernet LAN or an RS232 port. It is possible to:

  • Download the passages log from the PROX+, or the fingerprint images from the scanning units.
  • Upload downloaded fingerprint images into another FingerScan of the system.
  • Delete single fingerprint images or all the fingerprints associated with a specific user code.
  • Start the recording procedure of a new fingerprint and configure the system: baud rate, FingerScan's address, number of connected FingerScans.
  • Check the state of each FingerScan on the network.

Up

 

 

  • 906.001.20 FingerScan Fingerprint reading head for PROX+
    • 300 fingerprints capacity, RS485, T-BOX and 3m cable
  • 906.003.20 FingerScan Fingerprint reading head for PROX+
    • 1800 fingerprints capacity, RS485, T-BOX and 3m cable
  • 980.004.00 PS1400 Power supply adapter: 220Vac to 12Vdc @ 1,4A for FingerScan with encased wall plug (European
    two round pins - 10A)
  • 107.201.51 PROXfinger software for RAM Card. Unlimited licence for distributor.
  • 250.256.00 RAM-Card: 256 Kb
  • 250.212.00 RAM-Card: 512 Kb
  • 940.099.70 x Firmware updating 512 Kb EPROM. Please, specify P/N and languag e of the PROX+ terminal to be updated.(necessary for PROX+ with firmware r.x40 or previous)

Up

 


IVAR a.s., authorized TMC reseller in CR
address: Náměstí 5. května 3, 290 01 Poděbrady
phone: (+420) 0324 611018, 610181; fax: (+420) (0)324 610505
e-mail: